4POE+2RJ45 100M Standard POE Switch
Stonet P106C is a 100M standard POE switch that provides 6*10/100M adaptive RJ45 ports. Ports 1~4 features POE power supply capability and can be used as Power over Ethernet devices. The power supply port can automatically detect and recognize the powered device that complies with the IEEE 802.3af/at standard and supply power through the network cable.Supports two modes: normal switch mode/250M ultra-long transmission. P106C makes it easier for you to deploy wireless access point (AP) and IP terminal network devices using POE technology.

• Supporting 802.3 Ethernet, 802.u Faster Ethernet
• Supports POE IEEE 802.3af/at compliant Powered Device (PD)
• Modes: Normal switch mode/Extended mode(Port1-4:250Metres ultra-longtransmission)
• Ports 1~4 features POE power supply capability and can be used as Power overEthernet devices
• Auto MDI/MDIX crossover for all ports
• Support full duplex based on IEEE802.3x and half duplex based on Backpressure
• Support non-blocking wire speed forwarding
• MAC address auto-learning & auto-aging
• Steel case,the total POE power budget of 65W
• Plug and play


Hardware
Interface
4*10/100Mbps POE ports(Data/Power)
2*10/100M uplink RJ45 ports (Data)
Basic function
Follow IEEE 802.3 Ethernet and IEEE802.3u Fast Ethernet Protocol
Supports POE IEEE 802. 3af/at compliant Powered Device (PD)
Store-and-forward switching scheme
Support IEEE802.3X full duplex and Backpressure half duplex
MAC address auto-learning & auto-aging
Standards
IEEE 802.3 10BASE-T Ethernet
IEEE 802.3i 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3af/at, Power over Ethernet
IEEE 802.3x Flow Control
Mode
Normal switch mode/Extend mode
Data Transfer Rate
Etherent:10Mbps(Half-duplex);20Mbps(Full-duplex)
Fast Entherent:100Mbps(Half-duplex);200Mbps(Full-duplex)
Store & Forwarding
Yes
Switching Capacity
1.2G
MAC Address
Table Size
2K
Jumbo Frame
2048 byte
Environment
Operation Temperature:0?~40?
Storage Temperature:-40?~70?
Operation Humidity:10%~90% RH Non-condensing
Storage Humidity:5%~90% RH Non-condensing
Power Input POE
Standards
Single port maximum power 30W,
Whole switch maximum power 65W
Support over-current,over-voltage and short-circuit protection
Support Soft Start of High Power PD
Support sequential boot-up
Power Supply Pin:12+/36-
AC 110~240V 50/60HZ
Cabling type
100Base-TX: Cat 5e or better UTP/STP(?100m)
10Base-TX: Cat 5e or better UTP/STP(?250m)
Dimensions
(L x W x H )
124mm*115mm*33mm